Gemini Junior Accessories - Plastic Shim

Add an extra layer in between your cutting plates by using the Plastic Shim for the Gemini Junior.

Shims are used in die-cutting to make the cutting-plate-die-paper-cutting-plate sandwich a little bit thicker. This helps to get an even more precise cut from your dies, especially if they are highly detailed or thin.

To care for your shim, please flip and rotate after each pass. If the shim does start to bow, flip over and pass through until it is flat again, then continue to flip and rotate as normal.

• Designed to be used with the Gemini Junior
• Helps with intricate die-cutting
• Pack contains one plate

• Personalised items are made to order and usually despatched within 1-3 working days.
• If an item can be personalised the information required and any character limits etc will be shown on the product page.
• Please double check your personalisation - how you enter it will be how it appears on the product, including spacing & punctuation.
• Remember to inclue any 's if required, and that both these and spaces will all count towards any character limit (if applicable).
• Please do not include accents, special symbols or emojis as some of our processes will not allow this.
• If you didn't add the personalisation or upload a photo for the item on your order, please email us with the relevant information.
• Items which are personalised, bespoke or made to your specific requirements are non-refundable, unless damaged or faulty.
• Your statutory rights are not affected.